Opens, closes and empties comfortably (ab) water cycles.
Due to a unique combination of different special functions registered for a patent, this is reliably successful in the long term.

Anti-blocking automatic DBGM Reg.
The engine is automatically switched off after 3 unsuccessful closing attempts
And thus protected against overheating or damage.

High drainage performance DBGM Reg.
The flow is often stream -optimized.
Form (flowing and gentle transitions), opening (light width) and material (surface quality particularly smooth)
lead to a high flow speed.

High-performance drive DBGM Reg.
A powerful, especially for the requirement developed, drives
via a special gear the open and lock mechanism with 7 nm.

Remote control
Comfortable controllable - and environmentally friendly.
With switching switches, the valves are connected so that operation is only possible when the engine is switched off.

Repepeter closure dbgm reg.
A sensor recognizes obstacles when closing and stops the drive automatically.
The system then completely opened again completely and closes again with swing.

Manual emergency operation
The system can be operated manually in an emergency (e.g. power failure).
Tip: Pull out a small rotary wheel and turn out

Details
Lily electric ball tap valve system - plastic, 1 inch

Thread type: plug -in thread on both sides
Connection: 1 "Inside thread
Material: LM T101 polypropylene (PP), LMT 111 polyvinyl chloride (PVC), LMT 107 ethylene propylene-dia (EPDM)
Correspondence: Connection cable L0.8 m, alternating switch: 12 V, 10 A max., 4-pin
Lily electric ball tap valve system - 1 1/4 inches

Thread type: plug-in thread on both sides with integrated O-rings for lily pipe plug-in system gray yellow 40mm
Connection: Connection cable L0.8 m, 2-cable
Material: LM T101 polypropylene (PP), LMT 111 polyvinyl chloride (PVC), LMT 107 ethylene propylene-dia (EPDM)
Lily electric ball tap valve system - 40mm heated, including switch

Thread type: plug-in thread on both sides with integrated O-rings for lily pipe plug-in system gray yellow 40mm
Connection: 40 mm lily pipe system
Material: LM T101 polypropylene (PP), LMT 111 polyvinyl chloride (PVC), LMT 107 ethylene propylene-dia (EPDM)
Lily electric ball tap valve system-for tank direct connection

Connection: Connection for the Lilie pipe plug-in system gray yellow 40 mm with double-O-ring. Finally with 2 stainless steel adapters, seals and stainless steel screws
Material: LM T111 polyvinyl chloride (PVC), LM T107 Ethylene-propylene-Di (EPDM), LM T101 Polypropylene (PP), LM T105 Thermoplastic elastomeres (TPE), stainless steel,
Lily electric ball tap valve system - 40mm

Thread type: screw thread on both sides
Connection: 1 ¼ ", with connections
Material: LM T150 (brass), LM T107 Ethylene-propylene-diens (EPDM)
​